Sheet Metal Cost Calculator
Estimate the per-part cost of a laser-cut and bent sheet metal part: material by blank area, cutting time from cut length, bending from bend count, plus surface treatment.
Cut speed — mm/min · time per part — min
Accuracy: ±25%. Material is charged on the full blank area without a nesting yield factor (real utilisation is usually 70–85 %). Cut speed follows an empirical power law; real speed depends on laser power, assist gas and nozzle. Deburring, welding, assembly, packaging and margin are not included.
How the estimate is built
- Material — blank area × thickness gives volume; volume × density gives weight.
- Laser cutting — total cut length divided by cut speed, which falls as thickness grows (roughly v ∝ t−0.9). Doubling thickness more than halves the speed.
- Bending — bend count × seconds per bend, plus programming and setup amortized over the batch.
- Surface treatment — powder coating, zinc plating, anodizing; entered as a fixed per-part cost.
Formula
volume_cm3 = blank_area_cm2 × thickness_mm / 10
material = volume_cm3 × density / 1000 × price_per_kg / (1 − scrap)
cut_speed = k / thickness_mm^0.9
cut_min = cut_length_mm / cut_speed
bend_min = bends × seconds_per_bend / 60
setup_min = setup_minutes / batch_size
machine = (cut_min + bend_min + setup_min) / 60 × machine_rate
total = material + machine + surface Worked example
SPCC 1.0 mm, 300 cm² blank, 1200 mm of cut, 4 bends, ¥150/hour, batch of 100, ¥0.80 surface:
| Material (30 cm³ × 7.85 = 235.5 g) | ¥1.43 |
| Laser cutting (1200 mm @ 7000 mm/min) | ¥0.43 |
| Bending (4 bends + setup) | ¥1.83 |
| Surface treatment | ¥0.80 |
| Total | ¥4.49 per part |
Note which line is largest: for thin parts with many bends, labour time dominates material. Adding one bend costs about ¥0.33 here, equivalent to 55 g of steel.
What this does not include
- Deburring, tapping, countersinking
- Welding, riveting, assembly
- Hardware inserts and fasteners
- Nesting optimisation and sheet remnant loss
- Packaging, freight, overhead and margin
FAQ
Why is material underestimated?
Because the model charges the blank you specified, but a real sheet is nested: the area around your part is scrap you still paid for. With 75 % utilisation, actual material cost is about 33 % higher than this figure.
How do I estimate cut length?
From the flat pattern: perimeter plus every hole and cutout outline. A 300 cm² bracket with a dozen holes typically has 1200–2000 mm of cut. Laser time is a small share of cost, so being 20 % off here barely moves the total.
Is bending or cutting the bottleneck?
For thin sheet, bending. Laser cuts at metres per minute; a press brake does one bend every few seconds including handling. Above roughly 6–8 bends the bend count drives the price.